Clear Coat Kits

We sell many epoxy clear coat and urethane sealer kits. Check out the below guide to figure out which one is right for your project. Read More

We sell many epoxy clear coat and urethane sealer kits. Check out the below guide to figure out which one is right for your project.


WBU-520 Water Based Urethane Clear Coat comes standard with the "Classic" garage floor kits and is a great, safe, easy to use thin sealer that is non-flammable and high gloss. It features easy application, low VOCs, high flash point, lower odor than solvent-based epoxies and urethanes, and a hard, tough, stain-resistant finish. Not recommended for use on exterior sidewalks or driveways where constant exposure to direct sunlight is present, but great for indoor applications such as garage floors and basements.

 
Characteristics
  • High Gloss
  • Seamless and very easy to clean
  • Abrasion and chemical resistant
  • No odor as typical of solvent based paint
  • Meets the most stringent, severe V.O.C. regulations
  • Product Data Sheet - Link

 

HPU 747 - The High Performance Urethane Clear Coat is a clear two component polyester/aliphatic polyurethane floor sealer upgrade designed for maximum chemical resistance, abrasion resistance and UV-resistance. It is a flammable liquid and should only be used in a well-ventilated area, NEVER should it be used in a basement or poorly ventilated space. When the proper safety precautions are observed during application, HPU 747 will be a long lasting clear coat for garages, auto service centers, and especially exterior applications where its UV-resistance and durability will truly shine.

 
Characteristics
  • Outstanding resistance to U.V. in its category
  • Seamless and very easy to clean - high gloss
  • Excellent abrasion and chemical resistance
  • Strong fumes during application - requires organic vapor mask
  • Product Data Sheet - Link
   

Norklad 100 M - 100% Solids Clear Epoxy Clear coat (100-M and 100-UV) is a super thick, self leveling epoxy is mostly used by flooring professionals because of it's extreme durability and mil thickness.  100% solids is best applied with one of our epoxy floor squeegees. Applied at 100 sq/ft per gallon, Norklad 100 self levels over full broadcast color chip or rough floors. It is often seen on terrazzo floors with a glasslike surface. Once Norklad 100 is mixed with the converter, it only has a 30 minute potlife, so it is best reservved for professionals or with confidence. .

Read Less
  1. Home
  2. Clear Coat Kits
Labsurface LABFAST LO 85 Polyaspartic | Clear High-Speed Epoxy Hardener for Quick Curing - 2 Gallon Kit

Labsurface LABFAST LO 85 Polyaspartic | Clear High-Speed Epoxy Hardener for Quick Curing - 2 Gallon Kit

Labsurface's Labfast LO 85 Elevate your epoxy projects with Labsurface's Labfast LO 85 high-speed epoxy hardener. Formulated for quick curing, this hardener ensures a... more info
NEW
WBU-520 Clear Polyurethane - Water Based Aliphatic 250+ sq/ft

WBU-520 Clear Polyurethane - Water Based Aliphatic 250+ sq/ft

WBU-520 Clear is a two component high-gloss aliphatic polyurethane water based floor sealer that exhibits excellent characteristics for abrasion resistance, chemical... more info
NEW
Norklad 100 M - 100% Solids Epoxy Clear Coat 150+ sq/ft

Norklad 100 M - 100% Solids Epoxy Clear Coat 150+ sq/ft

1.5 Gallon Kit /  or 100-150 square feet of coverage These smaller kits are ideal for restrooms, foyers, enclosed trailers, and office areas. Norklad 100-M is a two... more info
NEW
Norklad 100 M - 100% Solids Epoxy Clear Coat 350+ sq/ft

Norklad 100 M - 100% Solids Epoxy Clear Coat 350+ sq/ft

3-Gallon Kit Norklad 100-M is a two part 100% solids epoxy broadcast coat that can be filled with decorative chips and colored sand mixtures to provide an... more info
NEW
HPU 747 - Urethane Clear Coat - Polyurethane Sealer .75 gal

HPU 747 - Urethane Clear Coat - Polyurethane Sealer .75 gal

Due to VOC restrictions that vary by state, you may receive the VOC-compliant version of this product if your shipping address resides in any of the following states:... more info
NEW
HPU 747 - Urethane Clear Coat - Polyurethane Sealer 1.5 gal

HPU 747 - Urethane Clear Coat - Polyurethane Sealer 1.5 gal

Due to VOC restrictions that vary by state, you may receive the VOC-compliant version of this product if your shipping address resides in any of the following states:... more info
NEW
Norklad 100 M - 100% Solids Epoxy Clear Coat 1500+ sq/ft

Norklad 100 M - 100% Solids Epoxy Clear Coat 1500+ sq/ft

15-Gallon Kit Norklad 100-M is a two part 100% solids epoxy broadcast coat that can be filled with decorative chips and colored sand mixtures to provide an infinite... more info
HOT
Norklad 100 UV - 100% Solids Epoxy Clear Coat Non-Yellowing 350+ sq/ft

Norklad 100 UV - 100% Solids Epoxy Clear Coat Non-Yellowing 350+ sq/ft

Norklad 100 UV is a two part 100% solids epoxy seal coat with added UV resistance additives that can be used either as a coating or filled with paint chips, marble chips... more info
NEW
HWU 420 Urethane Clear Coat - Non Yellowing UV Sealer 600+ sq ft

HWU 420 Urethane Clear Coat - Non Yellowing UV Sealer 600+ sq ft

(Highwear Urethane 420 is unavailable and backordered until end of December. Ordered product will be processed to ship following production, in order it is received)... more info
NEW
HWU 420 Urethane Clear Coat - Repair Kit 80-100+ sq ft

HWU 420 Urethane Clear Coat - Repair Kit 80-100+ sq ft

    HWU 420 is a three component aliphatic urethane floor finish that exhibits excellent characteristics for abrasion resistance, chemical resistance,... more info
NEW
Devoe Devthane 379 Urethane Clear Coat - Aliphatic Polyurethane 1 Gal [On Backorder - No ETA]

Devoe Devthane 379 Urethane Clear Coat - Aliphatic Polyurethane 1 Gal [On Backorder - No ETA]

This product is currently on backorder with no ETA Devoe Devthane 379 Clear 1 Gallon Kit   A high performance, two-component chemically-cured aliphatic urethane... more info
HOT