Call: 1-800-227-8479
Epoxy Floor Coating Kits and Decorative Flakes

m menu image  m home m cart

600GL Coatings Remover (SOY-Gel) - 5 gallon


Add to Cart:


  • Manufactured by: Franmar Corporation


600GL Coatings Remover was formerly known as SOY-Gel.

Want a better way to remove paints, urethanes, acrylics, epoxies, and enamels without the back-breaking work of sanding and chiseling? Made with 100% American Grown Soybeans, 600GL Coatings Remover does all that and more. Throw out the sand paper and put away the knee pads. Just put some 600GL on the coating to be removed, allowing you to work on another project. Let 600GL Coatings Remover do the work, not you! Within minutes you can see the power of 600GL start to lift the coatings, all while you spend time on other tasks. Not sure how many coats need to be removed? 600GL Coatings Remover doesn't care. One coat, five coats, twenty coats, 600GL will remove them all and leave you smiling. In addition 600GL Coatings Remover goes a long way, with one gallon giving you up to 200 sq. ft. coverage. That's THREE times the coverage of most traditional strippers! With 600GL you won't have to deal with harsh odors that we all know so well with other strippers. No odor 600GL Coatings Remover is the perfect helper for anyone wanting to remove paints, urethanes, and enamels. GO GREEN!

600GL Coatings Remover is safe to use on wood, brick, stone, metal, plaster, concrete, and many other surfaces. Do not use on plastic, PVC, rubber or dry wall. 600GL Coatings Remover may be used indoors or outdoors. When used outdoors, protect plant and vegetation with a plastic drop cloth. 600GL may be used on vertical as well as horizontal projects.

Apply a thick, even layer of 600GL Coatings Remover, generally between 1/16 and 1/8 inch to the coating to be removed by using pouring, brushing, or airless sprayer (piston pumped with tip of 519 or similar). If applying with brush, do not apply as you would paint. Don’t brush or scrape the surface until the stripper has had time to work. Check the progress of the stripping action by using a scraper to see if the coating is softened down to the surface. If not, wait longer and recheck. 600GL will remain wet and working for several hours. Longer is better. Let the stripper do the work. If 600GL Coatings Remover is left to sit outdoors, cover with a light plastic drop cloth to prolong the stripper's wet time. Once the coating is softened, remove it with a scraper, industrial wet vacuum, or other stripping tool. Reapply stripper, if necessary. Repeat steps above. After use, clean remaining thin residue with water, using a scrub brush and/or mop or power washer. Ensure to scrape or vacuum excess removed coating and 600GL before using a power washer for final cleaning. Always use care to prevent over spray from getting on surfaces other than the one being prepped. Allow surface to dry before further preparations.

• Flash Point: Above 200°F
• pH Level: 6.80 pH of 1/10 - wt/wt solution in soft water.
• Vapor Pressure: Not determined
• Odor: Mild Odor
• Conditions to avoid: Strong oxidizing agents.
• Health Hazards: May cause moderate eye irritation. *May cause delayed skin irritation. May be harmful if swallowed in large amounts.
• Packaged: Gallon
• Coverage: Horizontal - Up to 200 sq. ft. per gallon

Click on the following links for more information on 600GL Coatings Remover:
TDS (.pdf)
SDS (.pdf)

Copyright © 2018 Original Color Chips. Powered by Zen Cart.