Call: 1-800-227-8479
Epoxy Floor Coating Kits and Decorative Flakes



m menu image  m home m cart

Norklad 100UV / 100% Solids UV-CLEAR Epoxy (350+ sq/ft)

$235.00

Add to Cart:



Details

  • Model: NOR100UV-3
  • Manufactured by: Original Color Chips Company

Description

 

 

 

 

Norklad 100 UV is a two component 100% solids epoxy seal coat with added UV resistance additives that can be used either as a coating or filled with paint chips, marble chips and colored sand mixtures to provide an infinite array of color schemes or patterns. It is recommended for warehouses, kitchens, restrooms, and other areas where either a high build clear product is needed or where a decorative filled floor is desired and better UV resistance is needed. No odor.

SOLIDS BY WEIGHT: 100%

SOLIDS BY VOLUME: 100%

VOLATILE ORGANIC CONTENT:  Zero

RECOMMENDED FILM THICKNESS: 16-18 mils (100 sq/ft per gallon)

PACKAGING INFORMATION

1.5 gallon kits

3 gallon kits (2.95 gallons net approximately)

15 gallon kits (14.75 gallons net approximately)

MIX RATIO:  2 parts A to 1 part B

9.0 pounds part A (.99 gallons) to 4.15 pounds part B (.49 gallons) (volumes approx.)

Part A "Non-Regulated" 

Part B "CORROSIVE LIQUID N.O.S., 8, UNI1760, PGIII"

TENSILE STRENGTH:

ULTIMATE ELONGATION:

GARDNER VARIABLE IMPACTOR:

CURE SCHEDULE:

 

 

pot life – 1 1/2 gallon volume ………..………….... 25-35 minutes @ 70° F

tack free (dry to touch)…………...…………………………..…7-9 hours @ 70° F

recoat or topcoat.....…………….………….……………..... 12-16 hours @ 70°F

light foot traffic...………………………………..………..……16-18 hours @ 70°F

full cure (heavy traffic)... ……………………….………...…....2-7 days @ 70°F

PRODUCT MIXING:

This product has a mix ratio of 9.0# part A to 4.15# part B. Standard packages are in pre-measured kits and should be mixed as supplied in the kit. We highly recommend that the kits not be broken down unless suitable weighing equipment is available. After the two parts are combined, mix well with slow speed mixing equipment such as a jiffy mixer until the material is thoroughly mixed and streak free. After mixing, transfer the mixed material to another pail (the transfer pail) and again remix. The material in the transfer pail is now ready to be applied on the primed substrate. Improper mixing may result in product failure.

PRODUCT APPLICATION:

The mixed material can be applied by brush or roller. However, the material can also be applied by a suitable serrated squeegee and then back rolled as long as the appropriate thickness recommendations are maintained. Maintain temperatures and relative humidity within the recommended ranges during the application and curing process. If concrete conditions or over aggressive mixing causes air entrapment, then an air release roller tool should be used prior to the coating tacking off to remove the air entrapped in the coating.






Copyright © 2017 Original Color Chips. Powered by Zen Cart.